Dallas Fort Worth 5.0 Mustang Club - Noob header question

Page 2 of 2

Show 40 post(s) from this thread on one page

Dallas Fort Worth 5.0 Mustang Club (http://www.dfw50s.com/index.php)

- Performance (http://www.dfw50s.com/forumdisplay.php?f=30)

- - Noob header question (http://www.dfw50s.com/showthread.php?t=2678)

merlinmol

09-11-2013 12:58 PM

Most shops charge a flat rate for header install. Almost always $400.

JDMLOL

09-11-2013 02:39 PM

Quote:

Originally Posted by merlinmol (Post 49637)

Most shops charge a flat rate for header install. Almost always $400.

That's what I was charged.

Slowstang1_jgw

09-11-2013 02:45 PM

Sweet

Quote:

Originally Posted by wbt (Post 49634)

My car runs 10's N/A with them. I replaced a set of Dynatech headers with a set of Pype's. That car ran 180MPH at the Texas Mile naturally aspirated.

I can't definitively say how much they are worth as far as gains go but they are on some of the quickest/fastest N/A 5.0's out there.

Yes. I was running a Lethal O/R X with them.

I will be making a purchase for them soon, $$ for LT and then you have clearance issues. Thanks for the info

jayman33

09-11-2013 03:14 PM

Quote:

Originally Posted by Slowstang1_jgw (Post 49654)

I will be making a purchase for them soon, $$ for LT and then you have clearance issues. Thanks for the info

Ive installed 20+ sets of kooks. Never ran into clearance issues.

wbt	09-11-2013 03:26 PM

Quote:

Originally Posted by jayman33 (Post 49655)

Ive installed 20+ sets of kooks. Never ran into clearance issues.

Kooks are a mid-length design and they have recently produced a shorty.

The Dynatech's definitely had clearance issues with regards to how low they hung down.

The Pypes tuck in very nicely and don't have the same clearance issues. On-par with the Kooks and stock header/mid-pipe combo's.

All times are GMT -4. The time now is 12:07 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page