Help wrenching?
Anybody want to help install my longtubes? Kinda want them on for dyno day and next weekend is too busy.
|
When? I might can drive up and help. I'm a pretty good supervisor/beer drinker:pepper:
|
Getting it done at 830 tomorrow morning. Thanks though
|
Re: Help wrenching?
Where are you doing it? I might stop by after c&c, I want to see what all is involved.
|
Off of Preston. Message me your number
|
My buddy is helping him out at the Land Rover in Frisco.
|
Quote:
|
Quote:
Truestreet...hold please. Truestreet...hold please. Truestreet...hold please. Truestreet....dyno time? I can schedule you in three months. Hold please. |
Quote:
|
I can supervise and lend a helpful thought.....and maybe a helpful hand if needed.
|
Just a suggestion, lift the car, support the engine from below with a dead man, support the rear of the car with a dead man. Then remove the front k-member with rack and control arms attached. It will make your life a ton easier..
|
C&B at midnights? lol.. Get the job done union style! Good luck with the install, car will sound insane!
|
i just did mine last weekend. i hope you have a 2 post lift. if you can wait until the afternoon i can come help you.
|
Quote:
|
Midnight, I just heard you drive by....sounds quieter with the headers on compared to what it was!
|
All times are GMT -4. The time now is 03:32 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.