Help wrenching?
 

Anybody want to help install my longtubes? Kinda want them on for dyno day and next weekend is too busy.

When? I might can drive up and help. I'm a pretty good supervisor/beer drinker:pepper:

Getting it done at 830 tomorrow morning. Thanks though

Re: Help wrenching?
 

Where are you doing it? I might stop by after c&c, I want to see what all is involved.

Off of Preston. Message me your number

My buddy is helping him out at the Land Rover in Frisco.

You hiring? :drink_nl:

Please, like you work hard now. lol


Truestreet...hold please.


Truestreet...hold please.


Truestreet...hold please.


Truestreet....dyno time? I can schedule you in three months. Hold please.

Lol. It don't pay well.

I can supervise and lend a helpful thought.....and maybe a helpful hand if needed.

Just a suggestion, lift the car, support the engine from below with a dead man, support the rear of the car with a dead man. Then remove the front k-member with rack and control arms attached. It will make your life a ton easier..

C&B at midnights? lol.. Get the job done union style! Good luck with the install, car will sound insane!

i just did mine last weekend. i hope you have a 2 post lift. if you can wait until the afternoon i can come help you.

Job security, son. :yaoface2: I'm working on something for you fine people. I'll post soon!

Midnight, I just heard you drive by....sounds quieter with the headers on compared to what it was!