Go Back   Dallas Fort Worth 5.0 Mustang Club > Search Forums


Sponsored Ads
Welcome to DFW50s.com

Register to remove these ads.




Showing results 1 to 25 of 251
Search took 0.02 seconds.
Search: Posts Made By: NAVAG
Forum: Performance 01-10-2017, 10:30 PM
Replies: 4
Views: 8,745
Posted By NAVAG
I won't do gears either. I have a hydraulic press...

I won't do gears either. I have a hydraulic press at work but it's an hour away so it would turn into a big hassle. Reason why my new one has 3.55 where my previous was 3.31. Good intermediate gear...
Forum: Performance 01-01-2017, 08:08 AM
Replies: 3
Views: 7,575
Posted By NAVAG
From personal experience. I ran a BAMA tune in my...

From personal experience. I ran a BAMA tune in my 13 for three years then I started running into misfire codes. Then the number 8 cylinder started misfiring pretty consistently. Had to get rid of her...
Forum: General Discussions 01-01-2017, 07:56 AM
Replies: 6
Views: 10,328
Posted By NAVAG
Bad ass! I did a diy epoxy coat three years ago...

Bad ass! I did a diy epoxy coat three years ago that is still holding up. It's taken a beating too. Thinking about cleaning the shit out of it and adding a clear coat
Forum: Introduction 09-12-2016, 11:44 AM
Replies: 1
Views: 6,226
Posted By NAVAG
Welcome to the group! this site isn't as active...

Welcome to the group! this site isn't as active as it used to be. Hopefully we get some more people joining up. be patient if asking a question on any of the forums, sometimes it takes a few days for...
Forum: General Discussions 09-09-2016, 09:13 PM
Replies: 12
Views: 10,750
Posted By NAVAG
I live in the sticks. No one has ever bothered to...

I live in the sticks. No one has ever bothered to check for cats
Forum: General Discussions 07-16-2016, 12:53 AM
Replies: 10
Views: 8,930
Posted By NAVAG
I had Pypes axle back for approximately two...

I had Pypes axle back for approximately two weeks. Droned so bad I wanted to drive off a bridge.
Forum: General Discussions 07-16-2016, 12:51 AM
Replies: 9
Views: 10,482
Posted By NAVAG
Stainless Works has the best bang for your buck...

Stainless Works has the best bang for your buck IMO. There are some less expensive systems but if this is a DIY job with jackstands then I would pay more for proper fitment. I'm getting where laying...
Forum: Site News 05-20-2016, 07:07 AM
Replies: 9
Views: 11,123
Posted By NAVAG
Pics or gtfo!

Pics or gtfo!
Forum: Site News 05-20-2016, 07:05 AM
Replies: 9
Views: 11,123
Posted By NAVAG
EFI can be tricky. Make sure the electrical is...

EFI can be tricky. Make sure the electrical is sound even though the car was well maintained it is nearly 30 years old. One little bug in a sensor or bad wire and you can be chasing phantom problems...
Forum: Site News 05-19-2016, 05:45 AM
Replies: 9
Views: 11,123
Posted By NAVAG
One of my first mustangs was an 89. Loved that...

One of my first mustangs was an 89. Loved that car. I'm pretty far from Frisco and not sure if I have all the proper tools for the job anyway. Haven't worked on one of those engines in a while. But...
Forum: General Discussions 05-04-2016, 01:27 PM
Replies: 7
Views: 7,561
Posted By NAVAG
I hear ya, buddy. I think I'll make an...

I hear ya, buddy.

I think I'll make an effort to visit this forum every day and post more. Just been super busy plus I've gone anti-Internet especially Facebook. Been going back to actually living...
Forum: General Discussions 05-04-2016, 01:22 PM
Replies: 7
Views: 7,561
Posted By NAVAG
Plus haven't had time for car stuff. Been sinking...

Plus haven't had time for car stuff. Been sinking a lot of money into house mods. Sold most of my car stuff. Nearly all stock now.
Forum: General Discussions 05-04-2016, 01:17 PM
Replies: 7
Views: 7,561
Posted By NAVAG
I don't do Facebook other than selling parts....

I don't do Facebook other than selling parts. Just been too busy.

Plus the way this site has gone since fb, post something and no one sees it for days
Forum: Suspension 03-02-2016, 08:02 AM
Replies: 2
Views: 20,880
Posted By NAVAG
I've got a set of used SR springs sitting in my...

I've got a set of used SR springs sitting in my garage collecting dust...
Forum: Member's Rides 03-02-2016, 07:50 AM
Replies: 8
Views: 10,455
Posted By NAVAG
Update: Been really busy and haven't had much...

Update:
Been really busy and haven't had much time for car stuff.
I've owned the car for 3 years and 2 months and have 110,000 miles. Still runs great even with a shitty Bama tune. I upgraded to a...
Forum: Member's Rides 03-02-2016, 07:38 AM
Replies: 8
Views: 10,455
Posted By NAVAG
GT500 Quads...

GT500 Quads...
Forum: Member's Rides 03-02-2016, 07:34 AM
Replies: 8
Views: 10,455
Posted By NAVAG
Switched to BMR Springs and added 4-Piston...

Switched to BMR Springs and added 4-Piston Brembos on the front...
Forum: Performance 03-02-2016, 07:29 AM
Replies: 9
Views: 11,166
Posted By NAVAG
Sweet! I've been eyeballing the CJ for a...

Sweet!

I've been eyeballing the CJ for a while


Well done!
Forum: Suspension 08-08-2015, 10:38 PM
Replies: 2
Views: 7,273
Posted By NAVAG
I put koni orange shocks and struts and the ride...

I put koni orange shocks and struts and the ride is quite comfortable compared to stock. Also depends on wheel size and what springs too. After I switched to 20's the ride got bumpier but with 19s it...
Forum: Site Comments & Feedback 06-24-2015, 06:57 PM
Replies: 3
Views: 21,659
Posted By NAVAG
Thought I was the only one that noticed...

Thought I was the only one that noticed...
Forum: For Sale 06-09-2015, 01:29 PM
Replies: 6
Views: 3,974
Posted By NAVAG
Thinking about selling mine...need to unlock and...

Thinking about selling mine...need to unlock and unmarry it first... Although it still comes in handy even though I'm stock again - cleared a code the other day
Forum: For Sale 06-06-2015, 09:42 PM
Replies: 3
Views: 3,479
Posted By NAVAG
All sold

All sold
Forum: For Sale 06-04-2015, 09:37 PM
Replies: 3
Views: 3,479
Posted By NAVAG
Sold axle backs

Sold axle backs
Forum: For Sale 06-03-2015, 05:48 PM
Replies: 3
Views: 3,479
Posted By NAVAG
Bump. Still available. Willing to negotiate. Will...

Bump. Still available. Willing to negotiate. Will sell all parts separately. Right now they are sitting in my shed collecting dust when they could be making somebody a little faster and sound...
Forum: General Discussions 05-30-2015, 10:29 AM
Replies: 8
Views: 5,860
Posted By NAVAG
Next weekend is looking like I will finally be...

Next weekend is looking like I will finally be able to wash my car. Probably gonna be one of those all-day detail sessions.
Showing results 1 to 25 of 251

 
Forum Jump