View Single Post
Old 04-02-2013, 05:18 PM   #38
Grandpa
I> /\/\
 
Grandpa's Avatar
 
Join Date: Jun 2012
Location: A fender ahead of BlownAltered
Posts: 7,562
Default

Originally Posted by 46Tbird View Post
There is no way you will get 500 n/a hp between the rails on a $5k budget.



To get that 363" size you have to run a 4.125" bore which automatically means a $2000 aftermarket block. That doesn't include the machine work to clearance it for that big stroker crank and buying all the rods, pistons, rings, bearings, cam, timing set, etc etc etc. I'm not sure you could get that short block together for your $5k budget - and then all you'd have to bolt on it would be those sweet smogger '82 heads.

Concentrate your $$ where it counts. Your best bet is to buy one of those well built long- or shortblocks that other people have posted up. Let someone else take a hit on all that pricey stuff. Remember that you're going to have to spend a fortune in headers/exhaust, fuel system/carb, ignition, converter or clutch, transmission, rear end, suspension, etc to support ANY "500hp" engine combination.

Building a car ain't cheap, so when someone says they have a cheap and fast Fox body, they are talking about an '87-93 car with a nitrous kit that is living on borrowed time.
Exactly. Very well said.


Cheap, fast or reliable. Pick two because it's all you get.
Grandpa is offline   Reply With Quote