[whitboy82]

So, this weekend I installed the Lethal performance OR X pipe and OTAs to my car, which already had the Flowmaster Outlaw axle back mufflers. I'm having one problem though. The "C" clamps that attach the mufflers to the OTAs just don't seem to wanna hold my passenger side muffler tight enough. I try holding the muffler in place, then, with my impact drill, I tighten down the clamp until it can't tighten anymore. Problem is, even after that the darn muffler can still move. It is sturdy but with only a little force it will easily move to where it can touch the paint. And, it doesn't match the placement of the driver muffler.

Short of going to an exhaust shop, is there anything I can do to fix it?