Go Back   Dallas Fort Worth 5.0 Mustang Club > 5.0 Mustang Forum > General Discussions

General Discussions Discuss anything in general about your 5.0 Mustang that doesn't belong within the other categories here.


Sponsored Ads
Welcome to DFW50s.com

Register to remove these ads.




Reply
 
Thread Tools Display Modes
Old 06-07-2013, 03:06 PM   #1
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default dynoing the car today

I will say that instructions aren't always best. There have been many instances where I had to just look at something to figure it out.

Case in point: IKEA furniture.
DirtyD is offline   Reply With Quote
Old 06-07-2013, 03:15 PM   #2
Grandpa
I> /\/\
 
Grandpa's Avatar
 
Join Date: Jun 2012
Location: A fender ahead of BlownAltered
Posts: 7,562
Default

Originally Posted by DirtyD View Post
I will say that instructions aren't always best. There have been many instances where I had to just look at something to figure it out.

Case in point: IKEA furniture.
LMAO! I can so relate to that but with baby furniture! haha.


When I was doing my research about the Paxton, one of the common complaints was about how bad the instructions were even after being revised several times. At several steps there is points where you would have to go back to undo something a previous step told you to in order to do the next step. So you waste a lot of time going back and forth touching the same parts repeatedly. With some research, you can get instructions from other owners to explain how to do them to save time and frustration.

I despise stuff like that!
Grandpa is offline   Reply With Quote
Reply

Bookmarks




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump