I hate the look of the stock calipers but I can't afford brembos at the moment......so I painted them black. I was hoping this would 1) make them less noticeable and 2) make them look a tad better. I think it turned out as best it could - and special thanks to my wife as she did all the taping and painting!
I used the black G2 caliper paint from LM. I didn't use red because that would have highlighted the calipers, which is the exact opposite of what I wanted. I followed the instruction pretty close. 1) Put car on jacks and removed wheels. 2) Masked off the rubber/plastic components and part of the rotors. 3) Cleaned calipers with brake cleaner and a wire brush. 4) Put a light first coat on. 5) Waited 20-30 minutes and put second coat. 6) Waited again and put another coat on just the main part that is visible. 7) Let sit over night. 8) Re-installed the wheels this morning. 9) Finally, have to wait 24 hours before driving.
Also, I bought better paint brushes than was supplied in the G2 kit. The one supplied sucked balls. And, I used a wire brush to clean even though my car is fairly new and there wasn't much dust on the calipers.
Overall, I think this was a good, cheap mod for me in particular because my car is black and so are my wheels. And thus, my calipers do not stick out like a sore thumb.
Sorry for the shitty embedding of pictures. I am a newb.
__________________
2014 Ford Mustang GT (aka "Vivian") - M6 Stripper. Mods: Strut Tower Brace; Roush ABs; 18" by 10" SVE Drifts with 285 Nitto NT555s.
I like it! Believe it or not, within the next few days i will hopefully be doing mine blue seeing as im attemping to run a Sterling Gray, Matte Black, and Blue theme to my Pony! Let me know how it all holds up!
__________________
2014 Pony Edition, NOT parent sponsored.
SMR # 2940
Looks good! I am on the fence if I want to do mine in red or black, or just leave them till I get big brakes but the big brakes won't be any time soon at all.
__________________
Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Looks good! I am on the fence if I want to do mine in red or black, or just leave them till I get big brakes but the big brakes won't be any time soon at all.
I was going to leave them but I figured a bunch of other mods had priority over big brakes so this is the best I could do while I wait.
__________________
2014 Ford Mustang GT (aka "Vivian") - M6 Stripper. Mods: Strut Tower Brace; Roush ABs; 18" by 10" SVE Drifts with 285 Nitto NT555s.