Go Back   Dallas Fort Worth 5.0 Mustang Club > 5.0 Mustang Forum > General Discussions

General Discussions Discuss anything in general about your 5.0 Mustang that doesn't belong within the other categories here.


Sponsored Ads
Welcome to DFW50s.com

Register to remove these ads.




Reply
 
Thread Tools Display Modes
Old 07-19-2013, 04:03 PM   #1
2012mustang76123
Senior Member
 
Join Date: Jul 2013
Age: 34
Posts: 116
Default Whats the difference in full catback exhaust vs just axleback??

Never had a car that just sold the tips, what would be the difference between

http://www.amazon.com/Flowmaster-817...eywords=817496

vs

http://www.amazon.com/Flowmaster-817...eywords=817500

sound wise
2012mustang76123 is offline   Reply With Quote
Old 07-19-2013, 04:11 PM   #2
re-rx7
Banned
 
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 38
Posts: 2,405
Default

Never liked Flowmaster.
re-rx7 is offline   Reply With Quote
Old 07-19-2013, 04:25 PM   #3
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

Cat back systems replace all components of the exhaust system from the catalytic converters to the exhaust tips. Axle backs are from the axle back, which is the same thing as mufflers only.

And for the record, full exhaust is from the headers/manifolds back.
DirtyD is offline   Reply With Quote
Old 07-19-2013, 04:37 PM   #4
2012mustang76123
Senior Member
 
Join Date: Jul 2013
Age: 34
Posts: 116
Default

Originally Posted by DirtyD View Post
Cat back systems replace all components of the exhaust system from the catalytic converters to the exhaust tips. Axle backs are from the axle back, which is the same thing as mufflers only.

And for the record, full exhaust is from the headers/manifolds back.
so would the cat back system not let you pass inspection since it removes the catalytic converters?
2012mustang76123 is offline   Reply With Quote
Old 07-19-2013, 04:37 PM   #5
re-rx7
Banned
 
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 38
Posts: 2,405
Default

Originally Posted by DirtyD View Post
Cat back systems replace all components of the exhaust system from the catalytic converters to the exhaust tips. Axle backs are from the axle back, which is the same thing as mufflers only.

And for the record, full exhaust is from the headers/manifolds back.
Oh and the stock exhausr is pretty gd from the catback.
re-rx7 is offline   Reply With Quote
Old 07-19-2013, 05:00 PM   #6
jng2985
Senior Member
 
jng2985's Avatar
 
Join Date: Feb 2013
Location: Coppell
Age: 37
Posts: 394
Default

Originally Posted by 2012mustang76123 View Post
so would the cat back system not let you pass inspection since it removes the catalytic converters?
It doesn't remove the cats it bolts to the cats and replaces everything to the tips
jng2985 is offline   Reply With Quote
Old 07-19-2013, 05:05 PM   #7
TrueStreetTim
DFW5.0s Preferred Vendor
 
TrueStreetTim's Avatar
 
Join Date: Aug 2012
Location: McKinney
Posts: 676
Default

Originally Posted by 2012mustang76123 View Post
so would the cat back system not let you pass inspection since it removes the catalytic converters?
Cat-BACK just means everything from the end of the cats (not including the cats) and back is replaced. Cats are part of the mid-piping.



Oh and the stock exhausr is pretty gd from the catback.
And this. From cat to axle-back is sufficient with nothing measurable to be gained.
TrueStreetTim is offline   Reply With Quote
Old 07-19-2013, 05:07 PM   #8
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

Originally Posted by TrueStreetTim View Post
Cat-BACK just means everything from the end of the cats (not including the cats) and back is replaced. Cats are part of the mid-piping.





And this. From cat to axle-back is sufficient with nothing measurable to be gained.
Tim nailed it.
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Old 07-19-2013, 05:29 PM   #9
2012mustang76123
Senior Member
 
Join Date: Jul 2013
Age: 34
Posts: 116
Default

Originally Posted by Dan12GT View Post
Tim nailed it.
noticed you have a catback vs axleback, did you notice anything?
2012mustang76123 is offline   Reply With Quote
Old 07-19-2013, 05:36 PM   #10
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

Originally Posted by 2012mustang76123 View Post
noticed you have a catback vs axleback, did you notice anything?
I never had an after market axle back on it so I couldn't say much for gains between the two. It had to have picked up something though along with my Airaid. I dyoned bone stock 372/359 and after Airaid intake / Borla S-type catback it was putting out 382/387 at the 1st TS dyno day last year. No tune yet. So I'd say the catback attributed to a bit of those gains.
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Old 07-19-2013, 06:55 PM   #11
2012mustang76123
Senior Member
 
Join Date: Jul 2013
Age: 34
Posts: 116
Default

just found a deal on the first link for 177 shipped off ebay so picked it up.
2012mustang76123 is offline   Reply With Quote
Old 07-20-2013, 09:39 AM   #12
Rebelracer568
Senior Member
 
Rebelracer568's Avatar
 
Join Date: May 2013
Location: Sanger
Age: 34
Posts: 392
Default

I run flowmasters on my car there good sound and dont have alot of that annoying popping. Also gives car the old school muscle car sound
__________________
2014 sterling gray 5.0 mustang gt. MT82, 3.55 gears with few mods
1973 mercury comet 347ci Jerico 4 speed tranny
1978 mercury Capri 2.8l German v6
Rebelracer568 is offline   Reply With Quote
Old 07-20-2013, 10:22 AM   #13
2012mustang76123
Senior Member
 
Join Date: Jul 2013
Age: 34
Posts: 116
Default

Originally Posted by Rebelracer568 View Post
I run flowmasters on my car there good sound and dont have alot of that annoying popping. Also gives car the old school muscle car sound
that's basically what I'm looking for, thanks
2012mustang76123 is offline   Reply With Quote
Old 07-20-2013, 10:25 AM   #14
JDMLOL
Senior Member
 
JDMLOL's Avatar
 
Join Date: Mar 2013
Age: 33
Posts: 1,047
Default

Originally Posted by Rebelracer568 View Post
I run flowmasters on my car there good sound and dont have alot of that annoying popping. Also gives car the old school muscle car sound
I agree. I run the outlaws and they are about as loud as the muffler deletes without a ton of popping.
__________________

The Queen:
2013 Race Red Mustang GT 6MT: 20" AMR's, GT500 AB, JBA LT's and ORX, SCT SF3/X3, MGW Short Throw, Some Carbon Wrap, Spoiler Delete, Eibach Sportlines, Koni STR.T's, BMR LCA's, BMR Relo Brackets, BMR UCA, Freedom Racing PHB, Maximum Motorsports CC Plates, BMR Safety loop, DSS Aluminum DS
JDMLOL is offline   Reply With Quote
Reply

Bookmarks




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump