Go Back   Dallas Fort Worth 5.0 Mustang Club > 5.0 Mustang Forum > General Discussions

General Discussions Discuss anything in general about your 5.0 Mustang that doesn't belong within the other categories here.


Sponsored Ads
Welcome to DFW50s.com

Register to remove these ads.




Reply
 
Thread Tools Display Modes
Old 07-03-2013, 12:26 PM   #1
Dominic Toretto
Senior Member
 
Dominic Toretto's Avatar
 
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 41
Posts: 1,896
Default Tires for a 8.5 inch Wide Wheel

Doing some math. One inch is 25.4mm so a 8.5 inch wheel is 215.9mm wide. on my stock 18X8 wheel the width of the tire is 235mm so 9.25 inches, meaning the overlap of the tire from the wheel 1X1/8 inch overlap. A 265 (10.43inches) tire would overlap a 8.5 wheel by nearly two inches. Is that two wide a tire to fit on an 8.5inch wide wheel?

-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376

Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
Dominic Toretto is offline   Reply With Quote
Old 07-03-2013, 12:30 PM   #2
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

So do you have 8.5" wheels or 8" wheels?

265 is typically the maximum recommended max for a 8.5" wheel by most tire manufacturers.

255 is typically the maximum recommended max for a 8" wheel by most tire manufacturers.
DirtyD is offline   Reply With Quote
Old 07-03-2013, 12:44 PM   #3
Dominic Toretto
Senior Member
 
Dominic Toretto's Avatar
 
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 41
Posts: 1,896
Default

The wheels I plan on getting will be 8.5 inches. Was just comparing what the overlap would be compared to stock if I went with 265s for the 8.5 wheels I want to get. It is very difficult to match a tire sidewall wise for the sizes I want without spending close to $400 per tire.

-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376

Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
Dominic Toretto is offline   Reply With Quote
Old 07-03-2013, 12:53 PM   #4
saunupe1911
Senior Member
 
saunupe1911's Avatar
 
Join Date: Jan 2013
Posts: 278
Default

I look up the recommended tire widths for my 8.5 rims per tire because it varies. But 90% of manufacturers recommend 255 as the max. Bottom line, get at least 9 wide rims for the S197 platform so u can get up to 275 with no problem. I've been contemplating taking a chance on 265/35/20 for my 8.5 rims. It may be just fine. I'm currently on 245/40/20 and it's the perfect height to match 275 to 295. I simply will not ever put 255/35/20 on. Those side walls are just too small for a street car that weighs this much. Plus adding anything on the rear larger than 275 gives too much rake with 255/35 fronts
saunupe1911 is offline   Reply With Quote
Old 07-03-2013, 01:03 PM   #5
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

Are the new wheels 18x8.5? What's the wheel diameter so we can give you a better idea on what you are looking at.
DirtyD is offline   Reply With Quote
Old 07-03-2013, 01:08 PM   #6
Dominic Toretto
Senior Member
 
Dominic Toretto's Avatar
 
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 41
Posts: 1,896
Default

19X8.5 fronts and 19X10s rear.

-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376

Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
Dominic Toretto is offline   Reply With Quote
Old 07-03-2013, 01:18 PM   #7
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

Originally Posted by Dominic Toretto View Post
19X8.5 fronts and 19X10s rear.

-Alex
I would do a 255/40/19 on the front and 295/35/19 rear. Each will be 27" OD, slightly short than the stock tires you had.
DirtyD is offline   Reply With Quote
Old 07-03-2013, 01:25 PM   #8
Dominic Toretto
Senior Member
 
Dominic Toretto's Avatar
 
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 41
Posts: 1,896
Default

I haven't actually purchased the 19X8.5s yet as they are still on back order through americanmuscle.com. They do have the 18X9s in stock. I was considering running those with a taller sidewall.
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376

Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
Dominic Toretto is offline   Reply With Quote
Old 07-03-2013, 01:34 PM   #9
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

If the 8.5 are on back order, get 19x10 all around. Not only will it be the best balanced, but you can run a 285/305 staggered then.

18s don't look good on these cars unless they are on short tires. Wheel is too small for the wheel wells.

19s minimum to get the best looks.
DirtyD is offline   Reply With Quote
Old 07-03-2013, 01:34 PM   #10
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

Are you getting the OE 5 spoke 19" style replacement from AM?
DirtyD is offline   Reply With Quote
Old 07-03-2013, 01:39 PM   #11
Dominic Toretto
Senior Member
 
Dominic Toretto's Avatar
 
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 41
Posts: 1,896
Default

Originally Posted by DirtyD View Post
If the 8.5 are on back order, get 19x10 all around. Not only will it be the best balanced, but you can run a 285/305 staggered then.

18s don't look good on these cars unless they are on short tires. Wheel is too small for the wheel wells.

19s minimum to get the best looks.
Is the offset for the front the same as the back? Not sure if that will work.

Originally Posted by DirtyD View Post
Are you getting the OE 5 spoke 19" style replacement from AM?
No, getting the Bullitt wheels black with polished lips.

-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376

Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
Dominic Toretto is offline   Reply With Quote
Old 07-03-2013, 01:48 PM   #12
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

Originally Posted by Dominic Toretto View Post
Is the offset for the front the same as the back? Not sure if that will work.



No, getting the Bullitt wheels black with polished lips.

-Alex
Are they the deep dish wheel? It may be doable, but I'm not sure. Probably have to actually ask AM if you can run those on the front. May be too deep.

Too bad they don't make a 9" version of those
DirtyD is offline   Reply With Quote
Old 07-03-2013, 02:41 PM   #13
Dominic Toretto
Senior Member
 
Dominic Toretto's Avatar
 
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 41
Posts: 1,896
Default

Originally Posted by DirtyD View Post
Are they the deep dish wheel? It may be doable, but I'm not sure. Probably have to actually ask AM if you can run those on the front. May be too deep.

Too bad they don't make a 9" version of those
Yup very deep, like a 3inch lip.

-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376

Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
Dominic Toretto is offline   Reply With Quote
Reply

Bookmarks




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump