Go Back   Dallas Fort Worth 5.0 Mustang Club > 5.0 Mustang Forum > Interior/Exterior

Interior/Exterior Post new mods or questions about the inside or outside of your mustang


Sponsored Ads
Welcome to DFW50s.com

Register to remove these ads.




Reply
 
Thread Tools Display Modes
Old 08-23-2013, 02:08 PM   #1
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default Clicking Noise Inside Dash Upon Startup

This just started happening, seems as though it started happening around the sometime I accidentally hard coded some settings into the "my key" function (doubt it has anything to do with it, just coincidence)

Any who, I get this clicking noise when I first start the car, about 5-6 clicks from what sounds like something inside the dash then it goes away. No idea what this is. Anybody have ideas? I'll try to get it on video. Seems to do it on cold starts more often than warm starts.
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Old 08-23-2013, 02:16 PM   #2
JDMLOL
Senior Member
 
JDMLOL's Avatar
 
Join Date: Mar 2013
Age: 33
Posts: 1,047
Default

Ac on or off? Could be the actuators that direct airflow. I had a similar situation in my silverado where they would hang up sometimes.
__________________

The Queen:
2013 Race Red Mustang GT 6MT: 20" AMR's, GT500 AB, JBA LT's and ORX, SCT SF3/X3, MGW Short Throw, Some Carbon Wrap, Spoiler Delete, Eibach Sportlines, Koni STR.T's, BMR LCA's, BMR Relo Brackets, BMR UCA, Freedom Racing PHB, Maximum Motorsports CC Plates, BMR Safety loop, DSS Aluminum DS
JDMLOL is offline   Reply With Quote
Old 08-23-2013, 08:35 PM   #3
Mrjeremyt
Senior Member
 
Mrjeremyt's Avatar
 
Join Date: Jun 2013
Location: Cedar Hill
Age: 36
Posts: 220
Default

Gotta be an AC actuator...
__________________
'13 5.0 in deep impact blue, "The Blue Goose"
A few mods, just a daily.

94 F150 302
New project, thinking built, procharger, powerglide, tubbed, super sleeper
Mrjeremyt is offline   Reply With Quote
Old 08-23-2013, 08:46 PM   #4
grabberblue50
Member
 
grabberblue50's Avatar
 
Join Date: Sep 2012
Location: euless
Age: 47
Posts: 78
Default

probly the blend door mode actuator it is normally right behind glove box.
grabberblue50 is offline   Reply With Quote
Old 08-24-2013, 11:11 AM   #5
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

Does it with the A/C off as well
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Old 08-24-2013, 02:17 PM   #6
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

Caught the noise live:

http://www.youtube.com/watch?v=RbLOC...ature=youtu.be
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Old 08-24-2013, 04:58 PM   #7
Mrjeremyt
Senior Member
 
Mrjeremyt's Avatar
 
Join Date: Jun 2013
Location: Cedar Hill
Age: 36
Posts: 220
Default

Originally Posted by Dan12GT View Post
Most devinitely a blend door! Heard that plenty of times before. They go through a sequence on start up to verify movement. Check underneath the dash then pull the radio to figure out which one it is. Hope you don't have to pull the entire dash out
__________________
'13 5.0 in deep impact blue, "The Blue Goose"
A few mods, just a daily.

94 F150 302
New project, thinking built, procharger, powerglide, tubbed, super sleeper
Mrjeremyt is offline   Reply With Quote
Old 08-24-2013, 10:59 PM   #8
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

Ya i'm just going to tack it on the list of items I am going to have checked at the dealership.
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Old 08-25-2013, 01:29 AM   #9
Mrjeremyt
Senior Member
 
Mrjeremyt's Avatar
 
Join Date: Jun 2013
Location: Cedar Hill
Age: 36
Posts: 220
Default

Originally Posted by Dan12GT View Post
Ya i'm just going to tack it on the list of items I am going to have checked at the dealership.
Or that... lol
__________________
'13 5.0 in deep impact blue, "The Blue Goose"
A few mods, just a daily.

94 F150 302
New project, thinking built, procharger, powerglide, tubbed, super sleeper
Mrjeremyt is offline   Reply With Quote
Old 08-25-2013, 01:32 AM   #10
Mrjeremyt
Senior Member
 
Mrjeremyt's Avatar
 
Join Date: Jun 2013
Location: Cedar Hill
Age: 36
Posts: 220
Default

Although I don't quite understand why you would ask what it is if you have no intention of fixing it... Guess I should just keep my experience to myself and let everyone just guess at their shit...
__________________
'13 5.0 in deep impact blue, "The Blue Goose"
A few mods, just a daily.

94 F150 302
New project, thinking built, procharger, powerglide, tubbed, super sleeper
Mrjeremyt is offline   Reply With Quote
Old 08-25-2013, 02:15 AM   #11
Fast5.0
Junior Member
 
Fast5.0's Avatar
 
Join Date: Sep 2012
Location: Lucas, TX
Posts: 9
Default

+1 on the blend door. I had mine fixed by the dealer last October.
Fast5.0 is offline   Reply With Quote
Old 08-25-2013, 07:14 AM   #12
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

Originally Posted by Mrjeremyt View Post
Although I don't quite understand why you would ask what it is if you have no intention of fixing it... Guess I should just keep my experience to myself and let everyone just guess at their shit...
Maybe so I can have information regarding what my problem is so I can explain it to the dealer? I do have intension of fixing it through the dealer as I'm still covered under warranty.
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Reply

Bookmarks




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump