Go Back   Dallas Fort Worth 5.0 Mustang Club > 5.0 Mustang Forum > Interior/Exterior

Interior/Exterior Post new mods or questions about the inside or outside of your mustang


Sponsored Ads
Welcome to DFW50s.com

Register to remove these ads.




 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-28-2014, 07:23 PM   #6
Pewter Lurch
Senior Member
 
Join Date: Oct 2012
Location: Rowlett, TX
Age: 31
Posts: 163
Default

Originally Posted by TurboZ View Post
ballasts are the most common problem with cheap HIDs, also bulbs can be also. Swap each side and see if it transfers, just start with the ballasts. If it transfers then get another ballast, if it doesn't, swap the bulbs. If it still is on the same side you have a voltage problem. Ballasts won't continue to run with an under/over voltage condition, they have a set voltage range they work in. Sometimes it requires using a relay kit to use power directly from the battery to keep a constant good stream of 12v. Most of your smaller circuits in newer cars have quite a bit of voltage fluctuation as accessories get turned on/off, they're pretty sensitive to minor voltage drops.
Looks like it is a bad ballast. Swapped the ballasts and passenger side wont come on now.
__________________


2011 Mustang GT Premium
The Go Fast:
Magnaflow 3" OA | Pypes X-Pipe | Steeda CAI | VMP Tune | BBK Cat Deletes | SVT GT500 quad mufflers |

The Ride & Look Good:
Ford K Springs | BMR Adj. LCAs | BMR Relo. Brackets | BMR Adj. PHB | GT500 Spoiler | Boss Rear | Retrofit Headlights | GT/CS facia | Boss splitter | Retro billet grille | Steeda X Brace | Enkie RPF1 18x8/18x9.5 | '14 tail lights | '14 GT500 quad bumber |

Collecting Dust:
|Go Fast Parts(SHHHH no one knows)|
Pewter Lurch is offline   Reply With Quote
 

Bookmarks




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump