Go Back   Dallas Fort Worth 5.0 Mustang Club > Search Forums
Reload this Page Search Results
Become a Supporting Member         Become a Preferred Vendor


Sponsored Ads
Welcome to DFW50s.com
Register to remove these ads.




Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: DirtyD
Forum: Interior/Exterior 04-09-2014, 04:14 PM
Replies: 9
Views: 7,852
Posted By DirtyD
Maybe a difference in the relief of the spoke...

Maybe a difference in the relief of the spoke design? :shrug:

This is from TireRack. It seems that backspacing is how much room there is between the mounting pad and the back of the spoke/wheel.
Forum: Interior/Exterior 04-09-2014, 03:38 PM
Replies: 9
Views: 7,852
Posted By DirtyD
Yeah, I messed up. Guess I wasn't thinking clear...

Yeah, I messed up. Guess I wasn't thinking clear enough when I posted yesterday. That's my fault fellas. higher offset is set further away from the wheel center, meaning the inside of the wheel is...
Forum: Interior/Exterior 04-09-2014, 03:15 PM
Replies: 9
Views: 7,852
Posted By DirtyD
It depends on the design of the wheel too. If...

It depends on the design of the wheel too. If it's not really a deep concave wheel, a lower number will stick out, which I think is the case with new edge wheels.

Man, I thought I finally had this...
Forum: Interior/Exterior 04-08-2014, 06:26 PM
Replies: 9
Views: 7,852
Posted By DirtyD
*Messed up, so I deleted this first part.* I'm...

*Messed up, so I deleted this first part.* I'm not exactly sure on the max and min offset of each width, but I know most try for around +43mm on a x10 wheel
Showing results 1 to 4 of 4

 
Forum Jump
Vendors
Auto Accessories Garage
Big Worm Graphix
Brenspeed
Late Model Restoration
Precision Mustang Performance
Rock Auto
Team Beefcake Racing
Sponsors