Go Back   Dallas Fort Worth 5.0 Mustang Club > 5.0 Mustang Forum > General Discussions

General Discussions Discuss anything in general about your 5.0 Mustang that doesn't belong within the other categories here.


Sponsored Ads
Welcome to DFW50s.com

Register to remove these ads.




Reply
 
Thread Tools Display Modes
Old 02-02-2014, 12:20 AM   #1
Trey's 5.0
Member
 
Join Date: Dec 2013
Location: Crowley
Age: 38
Posts: 32
Angry Problems after S/C install need opinions

Car is lagging/sputtering really bad in every gear. Not sure what the problem is. Once over 3500rpm or so and WOT it runs like a champ. After driving 30min or so parked car for a couple hours went back out to start, would start up but then on idle down it would just cut off, took about 5 times to actually get it to start and keep running. Not sure what the problem is. Anyone have any ideas would be appreciated...
Trey's 5.0 is offline   Reply With Quote
Old 02-02-2014, 12:38 AM   #2
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

This sounds familiar...
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote
Old 02-02-2014, 01:49 AM   #3
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

Where did the install take place? And who tuned it?
DirtyD is offline   Reply With Quote
Old 02-02-2014, 04:58 AM   #4
Crimson600+HP
Senior Member
 
Crimson600+HP's Avatar
 
Join Date: Oct 2013
Location: CENTEX
Age: 36
Posts: 378
Default

All this without a check engine light?

Most likely the car is not running at WOT right either, you probably are not noticing the lack of power. Similar events just happened to my SC 2013, but I was throwing codes eventually.
__________________
- Jeff
_____________________________________________
2013 GT Premium|Brembo|MT82
ProCharger P1SC Stage 2|Full Suspension|New Plans: NA CJ Intake Manifold/OR H Pipe/3.73 Gears
Road Raced|Auto-X'd
Drag Raced|12.4s @ 119.7
Texas Mile|1/2 Mile: 140.3|1 Mile: 166.4|She had more in her!
Crimson600+HP is offline   Reply With Quote
Old 02-02-2014, 10:58 AM   #5
BV600
Senior Member
 
Join Date: Jun 2012
Location: Killeen
Age: 38
Posts: 391
Default

What injectors?
__________________
2014 GT- A6 - ORX - Kooks AB - BMR Springs LCA Relos Panhard - Strange Adj Shocks/Struts - 17/15 Darkstars - Procharger D1SC - ID1000s - VMP BAP
BV600 is offline   Reply With Quote
Old 02-02-2014, 12:03 PM   #6
Trey's 5.0
Member
 
Join Date: Dec 2013
Location: Crowley
Age: 38
Posts: 32
Default

JKS in mansfield did all the work, and tuned it on the dyno with an SCT. A/F is all over the place also. Running the 74lb injectors, 2.8LC kenne bell, Boost-A-Pump, Kooks Headers into Borla S-type cat-back. 1-piece driveshaft also but thats got nothing to do with it. Got a CEL after he was done the first time, P0219A which is A/F imbalance, took it back fixed it no CEL now just lag and sputtering.
Trey's 5.0 is offline   Reply With Quote
Old 02-02-2014, 12:23 PM   #7
re-rx7
Banned
 
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 38
Posts: 2,405
Default

#8 MOST LIKELY. Hopefully its just a tune issue.
re-rx7 is offline   Reply With Quote
Old 02-02-2014, 12:28 PM   #8
Trey's 5.0
Member
 
Join Date: Dec 2013
Location: Crowley
Age: 38
Posts: 32
Default

Kinda what I'm thinking, taking tomorrow to hopefully get it fixed. If not going to get another opinion from another shop that dyno tunes. Any suggestions if I have to go that route..?
Trey's 5.0 is offline   Reply With Quote
Old 02-02-2014, 01:42 PM   #9
BV600
Senior Member
 
Join Date: Jun 2012
Location: Killeen
Age: 38
Posts: 391
Default

Do you mean 72lb? I had a similar issue with my procharged 12, ended being the injectors flowed improperly.
__________________
2014 GT- A6 - ORX - Kooks AB - BMR Springs LCA Relos Panhard - Strange Adj Shocks/Struts - 17/15 Darkstars - Procharger D1SC - ID1000s - VMP BAP
BV600 is offline   Reply With Quote
Old 02-02-2014, 02:12 PM   #10
re-rx7
Banned
 
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 38
Posts: 2,405
Default

Try Tim at TS.
re-rx7 is offline   Reply With Quote
Old 02-02-2014, 06:03 PM   #11
DirtyD
Senior Member
 
Join Date: Jun 2012
Posts: 5,594
Default

Try some different injectors. If the spray pattern is messed up, then that would be the problem. Inconsistent fuel spray.

Pick up some FRPP 80#
DirtyD is offline   Reply With Quote
Old 02-03-2014, 12:02 AM   #12
BV600
Senior Member
 
Join Date: Jun 2012
Location: Killeen
Age: 38
Posts: 391
Default

Originally Posted by DirtyD View Post
Try some different injectors. If the spray pattern is messed up, then that would be the problem. Inconsistent fuel spray.

Pick up some FRPP 80#
I would try this. I went to some 72s from a off brand company who said "flow matched within 1%" lol wasn't the case.

Then Amazon who was tuning the car told me 60s and Id be find...Joke again.

Then Finally I spent the money on Lethals 72s

Probablly over 1000 in injectors not including the tuner change.....Learned my lesson
__________________
2014 GT- A6 - ORX - Kooks AB - BMR Springs LCA Relos Panhard - Strange Adj Shocks/Struts - 17/15 Darkstars - Procharger D1SC - ID1000s - VMP BAP
BV600 is offline   Reply With Quote
Old 02-05-2014, 10:49 AM   #13
Slowstang1_jgw
Member
 
Join Date: Aug 2013
Location: Haslet/ Het Trace area
Posts: 66
Default

Trey,

It’s the flux capacitor!
Slowstang1_jgw is offline   Reply With Quote
Old 02-05-2014, 01:41 PM   #14
five.slow
Senior Member
 
Join Date: Oct 2013
Age: 39
Posts: 243
Default

What's up with everyone jumping on the #8?

If you have a jacked up a/f. Check it with both o2 sensors. If they are both all over the place I'd say crap injectors. Honestly you should have just went strait to id1000s. Look at the maf too and see if it's all over the place.

Actually before all of that check for a vacuum leak with a can on carb cleaner while the car is running.
five.slow is offline   Reply With Quote
Old 02-06-2014, 08:40 PM   #15
Trey's 5.0
Member
 
Join Date: Dec 2013
Location: Crowley
Age: 38
Posts: 32
Default

No leaks, O2's are good, MAF's good. Thinkin it may be the injectors, he's ran a different tune about 4x's still the same. Runs great over 4k rpm anything under or in high gear jerks around like crazy. Must've put the wrong things in the flux capacitor
Trey's 5.0 is offline   Reply With Quote
Reply

Bookmarks




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump